![background image](http://html1.mh-extra.com/html/rands/eb500/eb500_getting-started_3080171068.webp)
Software and Firmware Update
R&S
®
EB500
68
Getting Started 4072.8432.02 ─ 04
4.5
Changing the IP Address
4.5.1
Using Update32 Tool
The IP address of the R&S
EB500 can be changed using the "Update32" tool. By
default, the R&S
EB500 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under
chapter 4.3, "Receiver Firmware Update for
EB500 without front control panel"
, on page 56 to read the steps for retrieving and
running the "Update32" tool.
Starting the procedure
Run
Update32
and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under
on page 59 to select an appropriate configuration file. Select
"Config” -> “LAN Settings via Ethernet" as shown below:
Selecting the target R&S
EB500
The R&S
EB500, for which you want to update the IP address, needs to be switched
on. Make sure there is a LAN connection between the R&S
EB500 and the PC. After
a short period, a new entry will be shown in the list of targets as shown in
. Select the appropriate target and press the "Start" button.
Changing the IP address
Make the desired changes in the LAN settings dialog as shown below. Select
“DHCP” if the R&S
EB500 is to be connected to a DHCP server.
Changing the IP Address