Page 18
WES
3
Installation and Operations Manual V2.0 Ramtech Electronics Limited 2020
Select ‘Yes’, and enter your access code when requested. During
the re-arming period the following message will be displayed for two
minutes.
At the end of the re-arming period the CONNECT unit will return to the
home screen unless any system warnings have been received during
the fire alarm or re-arm period.
System Warnings
The WES
3
CONNECT will indicate warnings from itself or any other
system unit. When a warning is received the screen will be illuminated
and the unit will beep periodically.
Some warnings, for example EXT, will self-clear if the fault is resolved.
Alarm
When an alarm has been raised by a Call Point or Detector, the
CONNECT unit will flash the LCD display, beep and display “ALARM
ALARM ALARM” together with which units raised the alarm. The
newest event will be at the top of the list.
Units are identified by unit number and unit type. F indicates a Call
Point, I an Interface and D a Detector. For example, the above shows
that a Call Point with the number 005 was activated at 08:38 on the 5th
August.
An alarm can be silenced in three ways:
i) Resetting a Call Point
ii) Waiting 30 minutes after the last activation
iii) Using your access code to silence the alarm from the CONNECT
unit
iv) A Sensor no longer detects smoke / heat and will stop the alarm
To silence the alarm from the CONNECT unit, press
R
during the
alarm. This will take you to the Silence Alarm screen.
Advanced
CONNECT Operation