RAK RAK19001, Быстрый старт

Страница: 9 / 31

Documentation Center
⚠ WARNING
Battery can cause harm if not handled properly.
Only 3.7-4.2 V Rechargeable LiPo batteries are supported. It is highly recommended not to use other
types of batteries with the system unless you know what you are doing.
Make sure the battery wires, both rechargeable and non-rechargeable, match the polarity on the
RAK19001 board. Not all batteries have the same wiring.
Solar Panel Connection
The battery can be recharged, as well, via a small Solar Panel, as shown in Figure 23. The matching connector
for the solar panel wires is an
JST ZHR-2 1.5 mm pitch female . A cable assembly for the solar panel connector
is also available for purchase in RAK store .
Figure 23: Solar panel connector V+ and GND
⚠ WARNING
Only 5 V solar panels are supported. Do not use 12 V solar panels. It will destroy the charging unit and
eventually other electronic parts.
The GND pin of the Solar Panel Connector is located on edge of the board. Make sure the solar panel
wires match the polarity on the RAK19001 board.
Software Setup
The WisBlock Core is designed to be interfaced with other WisBlock Modules like sensors, displays, and other
interfaces. To make useful devices, you need to upload a source code to the WisBlock Core. Before you continue,
you should have already set up either an
Arduino BSP or PlatformIO .
WisBlock Examples Repository
To quickly build your IoT device with less hassle, example codes for WisBlock Core are provided. You can access
the codes on the
WisBlock Example code repository . The example codes on folder
common
are compatible
with RAK4631, RAK11200, and RAK11310 WisBlock cores.
Last Updated: 7/29/2022, 10:17:19 PM