Documentation Center
Disassembling a WisBlock Module
1. The procedure to disassemble any type of WisBlock modules is the same. As shown in Figure 17, first, remove
the screws.
Figure 17: Removing screws from the WisBlock module
2. Once the screws are removed, on the PCB of a WisBlock module, there is a silkscreen that shows the correct
location where force can be applied. By applying even force under the marked area, the module can be
detached from the Base Board. See Figure 18 and Figure 19.
Figure 18: Detaching silkscreen on the WisBlock module
Figure 19: Applying even forces on the proper location of a WisBlock module to detach the module from the Base Board
Battery Selector
The RAK19001 supports both rechargeable and non-rechargeable batteries. You can also use this slide switch as
a power on/off switch to disconnect the battery from the board.
