RAK RAK19001, Быстрый старт

Страница: 14 / 31

Documentation Center
Figure 8: Non-Rechargeable battery connector pin label V+ and GND
Figure 9 shows how to select the battery type used for the project. The battery selector is based on the SS-12D10
slide SPDT switch . You can also use this slide switch as a power on/off switch to disconnect the battery from
the board.
Figure 9: Battery selector switch
⚠
WARNING
The voltage of the rechargeable battery must not exceed 4.3 V.
The voltage of the non-rechargeable battery must not exceed 5.5 V.
Solar Panel Connector
Figure 10 shows the solar panel connector V+(Vin) and GND. The matching connector for the solar panel wires is
an
JST ZHR-2 1.5 mm pitch female . A cable assembly for the solar panel connector is also available for
purchase in RAK store .
Figure 10: Solar panel connector V+ and GND
⚠
WARNING
The output voltage of the solar panel must not exceed 5.5 V. Otherwise, it may cause permanent damage
to the board.