Documentation Center
A suitable Li-Ion battery should have the following parameters as shown in the table below:
Non-Rechargeable Battery Connector
The RAK19001 WisBlock Base Board can be powered by a Non-rechargeable battery connected to the P3
connector. The nominal operating voltage of the battery should be within the range shown in the following table.
The matching connector for the battery wires is an
Solar Panel Connector
A 5 V solar panel can be connected to the board via the P2 connector to also serve the purpose of charging the
battery. The matching connector for the solar panel wires is an
Mechanical Characteristics
Board Dimensions
Figure 14 shows the detailed mechanical dimensions of RAK19001.
Parameter
Value
Charging Voltage
4.5 – 5.5 V
Charging Current
500 mA
Parameter
Value
Standard Voltage
3.7 V
Charging Voltage
4.2 V
Capacity
As required
Discharge current
At least 500 mA
Minimum
Typical
Maximum
Unit
3.3
3.7
5.5
V
