Raise3D
Pro3 Series Printer
Dual Extruder Printing (Advanced)
30
4.
Users can adjust parameters such as “Wipe Wall” in the “Oozing” tab.
Enable Wipe Wall
will add extra shell(s) around the model during dual-extruder printing. This wall(s) can
help clean the oozing filament from the unused nozzle to reduce the oozing of the model on the model.
Wipe Wall Offset
refers to the distance between Wipe Wall and the outer shell of the model. If the wall is
positioned too closely, the Wipe Wall may stick onto the model. If the wall is set too far, the wiping results
may be affected.
Wipe Wall Angle
refers to the maximum angle for generating the Wipe Wall. If the maximum angle is set
too low, the wall may have a difficult time following the shape of the model, especially around curved
surfaces.
Wipe Wall Loop Lines
refers to the quantity of the shells of wipe wall.
Wipe Wall Type
refers to the shape of Wipe Wall. There are the following 3 types of Wipe Wall. The
difference between them is the distance between the Wipe Wall and the model.
Contoured
is the Wipe Wall structure closest to the shape of the original model. In some cases, it will be
too close to the model which may be difficult to remove especially the inner structures.
Water Fall
will be generated along the origin shape, but if the lower structure is more narrow than the
upper structure, a vertically dropping wall will be created.
Vertical
a vertical type wipe wall will be created at the widest part of the model. It is ideal for simple
structures like tubes or cubes.
