Raise3D
Pro3 Series Printer
Dual Extruder Printing-Loading
23
H.
Dual Extruder Printing-Loading
Open the side door of the printer and install the
filament holder to the installation point. Take out
a spool of Raise3D Premium PLA printing
filament and install it on the holder.
Note:
If the filament is installed at points B and
D, it is recommended to place the filament in a
clockwise direction. If the filament spool installed
at points A and C, it is recommended to place the
filament spool in a counterclockwise direction.
Press and hold the quick connector on the
extruder and pull out the filament guide tube.
Find the end of the filament, and pass the
filament into the left/right inlet and through the
guide tube.
Note:
Here we take the left extruder as an
example, because the operation of the left
extruder is the same as that of the right extruder.
The left and right inlets are as shown in the
figure, please do not confuse them.
1.
2.
3.
