RainMaster ET Tracker, Руководство пользователя

Страница: 42 / 44

Rain Master Irrigation Systems Weather Station Manual
Page 37
Step 1 Disconnect the two wires from the Sensor Terminal board at terminals
Input 3 ( + ) and Input 3 ( - ). Connect a short wire (14 - 12 AWG) in
each of the Input 3 terminals.
Step 2 Observe the controller’s Rain display screen and note the present
value displayed.
Step 3 At the Sensor Terminal board, touch the two wires together
momentarily 2 or 3 times. (A Rain reading of .01” inches should be
recorded each time the wires are shorted together.)
Step 4 Re-check the Rain values on the controller Rain display screen. Verify
that the reading has increased .01” (1/100 inch) each time the wires
were shorted.
Step 5 End of Rain Data Checkout procedure.
Note: If readings change properly, the Sensor Terminal Input 3
is OK and the Controller is operating properly. Rain
Gauge reading problems must therefore be associated
with the Rain Gauge or its wiring. Check the Rain Gauge
installation and all connections.
If readings do not change properly, the problem lies
within the Controller. Check controller cables to make
sure that everything is plugged in correctly.
5.6 Wind Sensor Checkout Procedure
This procedure assumes that the wind sensor inputs 4 (+) and 4 (-) on the Sensor
Terminal board are functioning properly.
Proceed to the Rain/Wind display through the following menu sequences:
Step 1 If wind conditions exist, allow the anemometer to spin in the wind and
observe the wind reading display for a corresponding reading. It may
take up to a minute before the display begins to register a reading.
F1 = Main Menu
F3 = Status
F2 = Measurements
F5 = Rain/Wind
RAIN =.01/INCH
WIND = 000 MPH |
↑
|