Rainman Electric Manual
–
Page 17
3.
Replace impeller with needle-nose pliers using a rotating motion to
bend the fins and align the cross-screw with the slot in the shaft.
Push-fit instructions
Rainman watermakers use push-fit connectors for brine
waste and product water.
To connect, simply press the hose firmly into the connector.
To remove a hose from the Push-fit, press in the collet as
shown in the diagram.
Shipping
To prepare the unit for shipping:
1.
The travel plug must be in the high-pressure pump.
2.
The machine should be put inside a plastic bag before it is packed.
Service
If your watermaker exhibits any of the following problems, stop the unit immediately and consult a qualified
technician:
•
Unusual noises or vibration.
•
The system pressure will not reach 55 bar (800 psi).
•
With the unit running, there is no water flow through the green brine output water hose.
•
The white product hose continues to make salty tasting water after several minutes at 55 bar (800 psi).
•
Major leaks of water in the PSU or the RO unit.
Warranty
Rainman watermaker are guaranteed to be free of manufacturer defects and to perform within the published
specifications for a period of two years from the date of shipment to the original purchaser.
In the event of a warranty claim, Rainman Technology will inspect the defective component and repair or
replace at our discretion. Shipping charges are the responsibility of the purchaser to and from our facility in
Sydney, Australia.
The warranty is void if the system was mis-handled, abused, or not operated/maintained as directed by the
user manual. Consumable items, such as the filter cartridges, lift pump impeller, high pressure pump oil, high
pressure pump packings, or RO membranes are not covered under the terms of this warranty.
Rainman Technology’s liability under this warranty
is limited to repair or replacement of our systems to the
original purchaser. Under no circumstances is Rainman Technology liable for consequential damages related
to failure of the system to perform.
