KEYPADS
KEYPAD No. 1:
“PUMP”
When the power has been switched on the screen will light up, however the pool pump will not
operate unless the time is within a
“PUMP-ON”
period.
This keypad controls the operation of the pool pump and the controlling function of the unit. It
has three positions and scrolls through them with each press on the keypad.
The first press will move the pump status from
•
“AUTO”
to
“ON”
and the pool pump will
then run for one hour. The screen will show a message to confirm this.
Pressing the keypad again will move the pump status to
•
“OFF”
and the screen will confirm
this.
With a third press the pump status will return to
•
“AUTO”
and the timer will then switch the
pump on and off according to the times set.
Dosing of chemicals will only commence after a few minutes to allow for adequate mixing and
accurate monitoring. Similarly the safety warning sounds and alarm signals will not operate for
the first 5 minutes.
Should a manual
“ON-TIME”
longer than 1 hour be required, proceed as follows:
Press
•
“PUMP”
keypad No. 1 a few times until the screen message states that the pump is
operating under
“AUTOMATIC TIMER”
Press once more and hold down continuously keypad No. 1 until the required “ON-TIME” in
•
hours is displayed on the screen.
The unit will then operate for that number of hours and when all manually set times have
expired the unit will automatically return to “
AUTOMATIC TIMER
” to switch on and off the pool
pump.
If the Chemigem inbuilt pool pump timer is disabled by the pool operator, the unit will lose the
ability to turn the pool pump on manually with the “PUMP” keypad. To turn the pool pump on or
off manually when the timer has been disabled, use the mains power switch.
To reinstate the inbuilt timer, set “
AUTOMATIC PUMP TIMES
”
KEYPAD No. 2:
“ESCAPE” AND “ALARM MUTE”
The keypad has three functions: -
When the setup of the Chemigem is completed or required changes made, pressing the
•
ESC
keypad will return to normal display.
When alarms are sounding it can be pressed to mute the warning tone. The warning tone
•
will be restored when the unit next switches on.
The flashing red light remains on until the pool chemistry returns to the preset levels.
•
Removes lock-out associated with high pH alarm.
•
RAINBOW
POOL
PRODUCTS
PTY
LTD