Rain Master RME HAWK, Руководство пользователя

Страница: 65 / 72

1. Is the controller in Automatic Mode?
If No - Press
2. Ensure the Rain Switch is in the “Auto Watering”
position.
3. Does appear in left most position of display?
Yes - Rain Sensor is enabled and is reading a wet
condition (see SETUP)
4. Ensure that the Master Valve, Pump wiring and
SETUP is correct (see page 9).
5. Activate Manual System Check (page 42)
If station turns on, review programs: (page 39)
• Water Days
• Station Runtimes
• Percentage Valid
• Start Times
63
QUIT
TRO
U
B
LE
SH
O
O
TI
N
G
TROUBLESHOOTING
Symptom Action
Display is blank 1. Ensure controller has power and all wires are
properly connected.
2. Check secondary voltage of transformer for
24 VAC
No stations turn on
automatically
*
A problem with either flow or station field wiring
has occurred (see page 43).
Display alternates with
FAULT…PRESS…REVIEW
Place Rain Switch in “No Watering” position.
If station remains on then:
• Check for dirt in valve’s solenoid which will
cause the solenoid to stick
• Check for obstructions in valve, or torn
diaphragm
If station goes off then:
• Check station’s programmed watering time
• Check program percentage
A station remains on
Check installation/connections Figure 6 on page 13. Flow reading “000 GPM”
when water flowing
Flow not enabled.
• Check Flow Sensor Setup on page 53
Display never shows
“XXX GPM” when
water flowing