Rain Master RME HAWK, Руководство пользователя

Страница: 44 / 72

42
has a pump assigned to it (via SETUP) then the pump (Station 1 output) will come on
with the station.
MANUAL MASTER VALVE
This is used to run only the Master Valve for a selected time. The MV is designated as
Station 0.
EXAMPLE: You wish to run master valve for 4 min.
Press:
To stop:
Press:
MANUAL SYSTEM CHECK/SYRINGE CYCLE
As a convenience for "walk throughs" and service work, and to measure the flow rate on
a station, the controller has a system check feature built in. This will run each station,
from the first to the last, for a selectable time of 1 to 9 mins.
EXAMPLE: For a 3 min. System Check
Press: DO NOT PRESS ENTER
If the flow features have been enabled (via Setup) then the display will show the current
measured flow rate in GPM during the CHECK mode. If the flow features are not enabled
then CHECK will appear in the display.
To advance one station at a time:
Press:
To stop this cycle,
Press:
The controller goes back to the Automatic Mode.
Caution: This mode sequentially runs every station in the controller. For example
you have a 24 station unit but only use 23 stations, it will still apply power for Station
24 and while doing so will apply power to the Master Valve/Pump terminal.
This could be a problem for a system when you are using the Master Valve output to drive
a pump because during the period that Station 24 is activated, the pump will be pumping
against a closed system. If the system uses a master valve, it will be activated during the
MANUAL STATIONS
0
ENTER
WED
4
ENTER
QUIT
MANUAL
TUE
3
MANUAL
CLEAR QUIT