Rain Bird WS-PRO, Инструкция по установке, обслуживанию и устранению неисправностей

Страница: 38 / 78

Page
28
On the bottom of the Cross-Arm, on the
end where the wind sensor has been
installed, remove the two screws for the
Relative Humidity/Temperature sensor
Radiation Shield.
Un-tape the RH/Temperature sensor
from the bottom of the Cross-Arm.
Remove the “yellow” protective plastic
cap from the end of the sensor, by
slipping it off the end of the sensor.
This can be discarded as it will not be
used.
Insert the RH/Temperature sensor into
the end of the shaft of the Radiation
Shield. Insert it to a depth where it is
securely seated. Now secure the
Radiation Shield to the bottom of the
sensor Cross-Arm with the two (2)
screws you have previously removed.
FIGURE 13 - TEMPERATURE/RH SENSOR INSTALLATION DETAIL
INSTALLATION OF SOLAR
RADIATION PYRANOMETER:
Refer to FIGURE 14 below: