22
PRR S-2 Turbine Operating Instructions
and the engine will stop.
7. Bring the throttle to the “OFF” position to complete the Reset Feature.
Test the settings by running the engine. You may need to repeat the
procedure to further adjust the thresholds. And remember you can always
return to the Default Settings by using Reset Feature 18.
NOTE: Special note for steam engines only. Once you have reached reset
18 you have two options. Option 1 resets all the reset features except for
reset feature 27 (Chuff Rate) back to the default setting. Option 2 resets
all reset features back to the default setting. For Option 1, press the
horn/whistle button once after you have heard the 3 clanks and 3 clinks
this will reset all the reset features except reset 27 (Chuff Rate) back to
the factory settings. For Option 2, press the horn/whistle button again
you have now reset the remaining reset feature 27 (chuff rate) back to the
factory setting. All the reset features now have been set back to the
factory settings
.
Programming FYS Operation -
Reset Feature 28-(5 Clanks, 3 Clinks)
Reset Feature 28 allows you to turn the operation of the FYS sequence on
or off. When OFF, the FYS will not activate. To use, cycle to Reset 28 and
press the Horn/Whistle button. The engine will play a series of bells. This
indicates the current setting. Each time the Whistle button is pressed,
Proto-Sound® will cycle to the next available setting and provide the
appropriate bell indicator.
The settings for Reset 28
are 1 Bell = ON, 2 Bells =
OFF. When the desired
setting is reached, lock the
changes by interrupting the
throttle and cycling the
engine into forward.
In RESET Mode
Move The Throttle
Up & Down From
High Voltage To Low
28 Times
Listen For 5 Clank
And 3 Clink Sounds
Push The Whistle Button
Until You Hear
2 Bell Dings
Interrupt The Throttle
To “Lock-In”
The FYS Setting
H
