RadioLink Mini Pix, Руководство пользователя

Страница: 40 / 65

40
Receiver and flight controller MINI PIX setup:
By default, a newly purchased receiver will be set-up to simply hold all channels at their last known
position when the receiver and transmitter lose contact. This is not good because the flight controller
has no way to know that the Pilot has lost control of the vehicle. Instead the receiver must be set-up
to signal to the flight controller it has lost contact and there are two ways that it can do this (the
method depends upon the receiver):
“Low - Throttle” method - the receiver pulls the throttle channel (normally channel 3) to a value
below the bottom of its normal range (normally below 975).
With the LiPo battery disconnected:
1. Connect your flight controller to the mission planner and select Initial Setup >> Mandatory
Hardware >> Failsafe.
2. Set the Failsafe Options to one of the three options:
(1) “Enabled always RTL” to force the vehicle to always RTL even if flying a mission in AUTO mode.
(2) “Enabled Continue with Mission in AUTO” to allow the vehicle to continue with missions even