RadioLink Electronic Ltd
www.radiolink.com
9
Note
: Wrong power supply selection will not affect the charger. If battery power supply is selected,
there is no automatic current limiting function, which means the battery can be charged at a higher
rate.
Setting method: When the charging stops, short press SET button to enter the setting page, and the
blue background cursor comes to "POWER". Press SET button, and the cursor starts to flash. Then
press "+/▲" or "-/▼" buttons at the bottom of the screen to switch POWER to BATTERY, and then
press SET button to confirm the setting. Then press "+/
▲
" or "-/
▼
" buttons at the bottom of the screen
to set other parameters.
3.2 Supply low power warning
If the power supply to the charger is insufficient, the charger will automatically prompt "Supply Low
Power", the charger won't stop charging at this time but will automatically reduce the charging current.
3.3 Supply voltage over high warning
If the input voltage of the power supply to the charger is higher than 15.0V, the charger will
automatically prompt "Supply Voltage Over High" and the charger will automatically stop charging.
3.4 Supply voltage over low warning
If the input voltage of the power supply to the charger is lower than 10.5V, the charger will
automatically prompt "Supply Voltage Over Low" and the charger will automatically stop charging.
