29
Searching
•
Pager Screen:
Set to
On
if you want to
ignore common pager frequencies.
•
Only Mode:
Set to
On
to turn off normal
scanning while Signal Stalker I runs. Set to
Off
to continue normal scanning while Signal
Stalker I runs in the background.
•
Band Switch:
Set the frequency band
where you want the scanner to look for
transmissions.
0
25-54 :
VHF Low Band
1
108-137:
AIR Band
2
137-174:
VHF High Band 1
3
216-320:
VHF High Band 2
4
320-512:
UHF Band
5
764-956:
800MHz Band
•
Voice Interrupt:
While the Signal Stalker
I is on and the scanner is receiving an
audio signal (voice) in normal scanning, the
scanner checks the Signal Stalker I every 2
seconds causing the audio signal to break at
that moment.
Set Voice Interrupt to
On
if you want to
keep the Signal Stalker I active despite
interruptions while the scanner is receiving
an audio signal. Set to
Off
if you do not want
to hear interruptions. The scanner resumes
checking signals when the audio signal ends.
•
Logging:
Set this function to
On
to scan log
channels along with normal channels. Set
this function to
Off
if you do not want to scan
log channels.
Log Channels
•
When the scanner finds a strong signal, it
automatically saves the signal to one of
10 log channels. If the scanner finds a new
frequency after the 10 log channels are
fully stored with frequencies, the oldest
