MAINTENANCE INSTRUCTIONS
39
Safety thermostat
(see fig. 1)
•
Disconnect the connecting wire;
•
Unscrew the fixing screws and remove the
thermostat;
•
Replace the thermostat and re-assemble the
components following the above procedure in
reverse order;
•
Switch on the electricity, water and gas supplies and
restart the appliance.
Heating sensor
(see fig. 1)
•
Un-Plug the connecting wire;
•
Replace
the
sensor
and
re-assemble
the
components following the above procedure in
reverse order;
•
Switch on the electricity, water and gas supplies,
open the shut-off valves and fill the central heating
circuit. Then restart the appliance, remembering to
discharge any air that may be trapped in the system;
Gas valve
(see fig. 2)
•
Disconnect the joints and remove the gas pipe
connecting the gas valve to the venturi.
•
Disconnect the gas feed pipe and valve ring-nut at
the bottom of the room-sealed chamber.
•
Remove the flanged elbow coupling of the existing
valve and fit it to the new valve; also fit a new cork
washer.
•
Replace the gas valve and re-assemble the
components following the above procedure in
reverse order.
•
Replace all the gas seals.
•
Fully tighten the gas connections.
•
Switch on the electricity, water and gas supplies and
check for any gas leaks using a soapy solution or
leak detector spray;
gas valve
Fig. 2
heating
sensor
safety
thermostat
Fig. 1
Содержание RK 34/B Ekobox
Страница 2: ......