Racktivity ES1100 Series, Руководство пользователя

Страница: 38 / 55

© 2011 Racktivity NV 38/55
Antwerpsesteenweg 19 - 9080 Lochristi - Belgium - www.racktivity.com v 2013.10.7
RS232
The RS232 ports on your EnergySwitch can be used to connect to the RS232 connectors of
external devices (CONSOLE port on a switch, …). Depending on your firmware version the means
of establishing a connection will vary. The firmware version is shown on the Web Interface or TFT
display.
Please note that only 1 RS232 port can be used/active at a time. Opening a second RS232 port
on the EnergySwitch will close the first connection.
Versions
Firmware version 1.0.1.3 or lower

Connect to the CLI Interface (see the CLI chapter)

The “OPENCOM” command can now be used to open a specific RS232 port

Use the HELP command for more detailed info (to open RS232 port 4 at 19200 Baud the
command would be “OPENCOM -c4 -b19200”)

Open a new telnet session to the EnergySwitch on port 2000 and login

You are now connected to the desired RS232 port
Firmware version 1.0.1.11

Connect to the CLI Interface (see the CLI chapter)

Use the command “SET M1 UARTMUXBAUD X” (with ‘X’ being the baud rate (max
115200Bd)

Use the command “SET M1 UARTMUXPORT X” (with ‘X’ being the port number (from 1 to
8))

Open a new telnet session to the EnergySwitch on port 2000 and login

You are now connected to the desired RS232 port
Firmware version 1.2

Please follow the instructions from firmware version 1.0.1.11

After setting up the RS232 port open a new telnet session to the EnergySwitch on port
200
X (with ‘X’ being the port number (from 1 to 8) that was used in the previous steps).
From this firmware version on the CLI port numbers are fixed values ranging from 2001
for CLI port 1 to 2008 for CLI port 8.