Distributor of Digi International: Excellent Integrated System Limited
Datasheet of 101-0453 - MODULE RABBITCORE RCM2300
Contact us: [email protected] Website: www.integrated-circuit.com
Getting Started Manual
11
2.3.3 Connect Power Supply
When the above connections have been made, you can connect power to the RabbitCore
Prototyping Board.
Hook the connector from the wall transformer to header J5 on the Prototyping Board as
shown in Figure 6. The connector may be attached either way as long as it is not offset to
one side.
Figure 6. Power Supply Connections
Plug in the wall transformer. The power LED (DS1) on the Prototyping Board should light
up. The RCM2300 and the Prototyping Board are now ready to be used.
NOTE:
A
RESET
button is provided on the Prototyping Board to allow hardware reset
without disconnecting power.
To power down the Prototyping Board, unplug the power connector from J5. You should
disconnect power before making any circuit adjustments in the prototyping area, changing
any connections to the board, or removing the RCM2300 from the board.
Reset
Switch
AC Adapter
PE3
GND
PD6
PD2
PD1
PD0
PD7
J1
Y1
VCC
VBA
T +
GND
R22
R21
C14
C13
D2
D3
C3
R38
R41
R39
RT1
D1
R7
R8
U6
R37
Y3
R18
C24
U2
R29
C23
C9
R17
R19
G
R34
WD
J3
VCC
VCC
PE6
BEN
C4
R36
C27
R1
C8
R2
C10
JP2
JP1
R23
R13
C11U1
R15
C12 C15
R26
Q2
Q3
Q4
Q5
R20
J2
RCM2300
DIAG
PROG
Prototyping
Board
16 / 31
16 / 31