12
Base Station
Bottom
For the Hearing Impaired
Recorded messages can be heard
from an intercom or Public Address
system by connecting the amplifier
to the LINE OUT terminals located in
the compartment under the Base
Station (See below).
Use the volume control of the
amplifier, NOT the “Volume” knob on
the SoundAlert Base Station.
To set the output duration
of each connection:
1. Move the slide switch to the
“RUN” position.
2. Press and hold the “PLAYBACK”
button for 2 seconds to activate
SETUP MODE.
3. In SETUP MODE, toggle
through the setting sequence for
each message button #1 - #4 to set
the output duration for each terminal
output connection. The three LED’s
will indicate the time duration
setting (see chart below).
4. Press the “PLAYBACK” button to
lock in each chosen setting and
return to operating mode.
5. Repeat steps 1,2,3 and 4 to set
time duration for each connection.
Note: To disarm the SoundAlert
System when the “CONTINUOUS”
setting is triggered, turn OFF the
Base Station with the “POWER”
switch. When “POWER” is turned
back ON, the system will return to
operating mode.
LINE OUT
Terminals
12
SA Manuel.indd 12
4/29/05 3:06:50 PM