12
Base Station
Bottom
For the Hearing Impaired
Recorded messages can be heard
from an intercom or Public Address
system by connecting the amplifier
to the LINE OUT terminals located in
the compartment under the Base
Station (See below).
Use the volume control of the
amplifier, NOT the “Volume” knob on
the SoundAlert Base Station.
To set the output duration
of each connection:
1. Move the slide switch to the
“RUN” position.
2. Press and hold the “PLAYBACK”
button for 2 seconds to activate
SETUP MODE.
3. In SETUP MODE, toggle
through the setting sequence for
each message button #1 - #4 to set
the output duration for each terminal
output connection. The three LED’s
will indicate the time duration
setting (see chart below).
4. Press the “PLAYBACK” button to
lock in each chosen setting and
return to operating mode.
5. Repeat steps 1,2,3 and 4 to set
time duration for each connection.
Note: To disarm the SoundAlert
System when the “CONTINUOUS”
setting is triggered, turn OFF the
Base Station with the “POWER”
switch. When “POWER” is turned
back ON, the system will return to
operating mode.
LINE OUT
Terminals
13
Troubleshooting
No Sound
• Check the “POWER” switch on
your Base Station. RIGHT is ON,
LEFT is OFF.
• The slide switch on the Base
Station must be in the “RUN”
position.
• Turn up the volume control knob
of the Base Station.
• Check the AC adapter. It must be
properly connected to the Base
Station and an active wall receptacle.
• Test the message by pushing the
appropriate message button located
on the Base Station.
• A Sensor/Transmitter must have
been programmed to activate the
voice message. If the program of
the Base Station gets deleted, you
must follow the instructions on
Page 10 (Programming One or
More Sensor/Transmitters to
Activate Additional Messages).
The Sensor/Transmitter will
not operate SoundAlert
• Check the Sensor/Transmitter 9
volt battery.
• Check the power connection to
the Base Station.
• Follow steps on Pages 7-11
(Sensor/Transmitter Installation).
• Make sure the steps are followed
on Page 10 (Programming One or
More Sensor/Transmitters to
Activate Additional Messages).
VERY IMPORTANT: If the Base
Station “SET UP” LED does not
glow, the Sensor/Transmitter was
not programmed and the proce
dure will have to be repeated.
Poor Distance
• Check the Sensor/Transmitter
battery.
• Check the Base Station DC
Power source.
• Check the Base Station with a
different Sensor/Transmitter.
• Check that the Sensor/Transmitter
is not fastened to metal. Move the
Base Station about 1 foot in any
direction.
Cannot Record a Message
• Turn on Base Station power
• Turn the volume control up
• Make sure that the slide switch of
the Base Station is in “RECORD”
position.
• Check the connection to the Base
Station power.
Cannot Playback a Message
• Turn the volume control up
• Make sure that the slide switch of
the Base Station is in “RUN” position.
Press the desired message button
(#1-#6)
• Check the connection to the Base
Station power.
Poor Volume
• Turn the volume control up
• Re-record the message with your
mouth a little closer to the micro
phone, (speak loud and clear)
• Check the connection to the Base
Station power.
Playback Distortion
• Reduce the volume control
• Re-record the message with your
mouth a little further from the
microphone
• Check the connection to the Base
Station power.
13
SA Manuel.indd 13
4/29/05 3:06:50 PM