RAB Lighting Gotcha! Plus GT500, Руководство по установке

Страница: 9 / 13

8
Problem:
Passing cars activate sensor.
Solution:
A 20’ safety zone between
the sensor and road is recommended
to avoid activation from passing cars.
6. Make sure heat from lights is not
triggering sensor. Make sure the
sensor is below and as far as possible
away from lights.
7. Make sure sensor is not in initial 60 sec
warm up period. Warm up period will
activate every time power is turned
off and re-applied to sensor.
1. Make sure sensor is not aimed at
something that would move or
change temperature such as waving
branches, water, air conditioners,
windows or heating vents - even on
neighboring property. You can test
for infrared sources in the area by
placing a box or bag over the sensor.
Put sensor into Test Mode. After the
initial 60 seconds of the lights being
on, lights should stay off. Wave your
hand inside the bag in front of sensor.
Lights should go on and then time
out. If sensor operates properly when
covered, check items 2-6.
Problem:
Sensor is triggered by
unwanted movement or heat source.
Solution:
Tilt sensor or mask lens
in the direction of the source. Move
sensor or source.
2. Make sure sensor is mounted firmly
and does not move even slightly
when touched. If it moves, tighten all
screws.
3. Make sure that Sensor is not mounted
on an unstable object such as a tree or
a pole that will move in the wind.
4. Was sensor wired hot? If so, circuitry
may have been damaged.
5. Make sure sensor is not aimed within
30 feet of a road.
Branches
blowing may
activate
sensor
You may tilt sensor to not aim in the
direction of the street or mask top of
sensor lens to reduce range (Pg. 8)
Technical Tips:
Lights Do Not Turn Off
Troubleshooting