R82 Quokka, Руководство пользователя, Страница: 15 / 68

REAR FACING
LAP-SHOULDER BELT ONLY
•
Figure A illustrates a rear-facing, lap
shoulder belt installation.
•
When not in use, lower connectors
MUST be stored by connecting them
together and tightening the strap
against the back of the child restraint
shell.
1. Place the child restraint in the rear-
facing position on the vehicle seat.
Recline the child restraint by using
the alignment sticker located on both
sides of the restraint. Align the black
line parallel to the ground (Fig . B ).
•
This child restraint MUST be in the
reclined position when installed rear
facing.
2. Lift the cover to open the rear facing
belt guide farthest from where the
vehicle belt will be buckled (Fig. C).
3. Pull the vehicle belt out, then route
the lap potion of the vehicle belt
across the child restraint passing
through the rear facing belt path. (Fig.
D).
•
The lap portion of vehicle belt MUST
be routed under cover and passed
through the rear facing belt guides on
both sides.
4. Route the shoulder belt across seat
then through the opposite rear-facing
belt path and under the support bar.
5. Verify that the vehicle belt is not
twisted, then buckle (Fig. E).
6. Push the child restraint firmly into the
vehicle seat while removing slack
first from the lap portion of the
vehicle belt. Adjust the shoulder
portion until the belt sits firmly inside
the shoulder belt guide.
INSTALLATION FOR CHILDREN 2.3-18 kg (5-39.6 lbs.)
13