1
/ 36
User Manual
Rev. 1.0 - 28/02/11
PJ1000C/1300C/2000LCD
ELETTRONICA
In the same menu, ensure that power limiting is disabled: if
PWR
is set to
OFF
,
i.e. power output is disabled, move cursor to
PWR
. Press
ENTER
and label
will switch to
ON
, i.e. power output enabled.
Press
ESC
twice to go back to the
default menu
(menu 1).
3) Fine tune power setting from menu 2 (see description of item 1b) until achieving
the desired value.
WARNING: Machine is capable of delivering more than rated output power
(1000/1300/2000 W); however, never exceed the specified power rating.
NOTE: Exciter drive power setting should never exceed 30W, or it will trigger
an Overdrive Alarm.
NOTE: If power is set to 0 W in the
edit mode
, the INTERLOCK OUT contact
trips and external exciter power is immediately inhibited.
Next, you can review all operating parameters of the machine through the
management firmware.
Normally, the machine can run unattended. Any alarm condition is handled
automatically by the safety system or is signalled by the LED indicators on the
panel or by display messages.
NOTE: Standard factory settings are: output power set to upper limit (unless
otherwise specified by customer) and
OFF
.
5.4 Management Firmware
The machine features an LCD with two lines by 16 characters that displays a set
of menus. Figure 5.2 below provides an overview of machine menus.
The symbols listed below appear in the left portion of the display as appropriate:
(Cursor) - Highlights selected (i.e. accessible) menu.
(Filled arrow) - Editable parameter marker. This symbol appears in menus that
take up more than two lines to aid browsing.
(Three empty arrows) - Parameter is being edited.
(Empty arrow) - Current line marker; the parameter in this line cannot be
edited. This symbol appears in menus that take up more than two lines to aid
browsing.
