15
BA_BM_ERGOPLAN-1-2-3_EN_46-21.docx
7
Transport to the Installation Site
Only trained personnel may be used for the following work:
•
Transport the Ergoplan
•
Unloading the Ergoplan
•
Check delivery condition of the Ergoplan
7.1
Unloading the Ergoplan
There is an increased risk of accidents when unloading and transporting the Ergoplan!
The Ergoplan can fall or tip over due to its weight!
Use only suitable and technically perfect lifting gear and suspension systems with an
adequate lifting capacity of 500 kg.
Only transport the Ergoplan on level, solid ground!
When placing the Ergoplan, pay attention to the possible danger of crushing in the area
of stationary objects around the Ergoplan!
Warning: Increased risk of injury and death! Never stand under the load when lifting
and putting it down! Instruct bystanders to leave the danger zone!
Warning: Increased risk of injury and death! Do not enter or climb onto the forklift
platform during transport!
Increased risk of crushing feet and toes! Wear steel-toed safety shoes!
Unloading by forklift truck
•
With the forks set appropriately, drive centrally into the designated places on the freight pallet on the longi-
tudinal side of the Ergoplan and lift carefully.
•
Carefully lift the Ergoplan from the truck. The net weight of the Ergoplan is approx. 240 kg (EP1 | FH), approx.
210 kg (EP2 | FH) and approx. 135 kg (EP3 | FH), each without accessories.
Check delivery condition
•
Check for completeness and transport damage. In case of transport damage or missing parts, document these
immediately on the consignment note of the transport company. At the same time, inform the manufacturer
of the situation.
Unpacking and placing
•
Unpack the Ergoplan and remove the packing material. Then
lift the Ergoplan from the transport pallet with a forklift. When
doing so, drive under the centre of the long side of the Er-
goplan with appropriately adjusted forks (see
Figure 6) and
carefully lift slightly. Then lift carefully from the pallet, remove
the pallet and set the Ergoplan down on the ground.
Dispose of packaging material in an
environmentally friendly manner!
Figure 6: Transport to the installation site
Fire hazard! Do not smoke or light an open fire.
Transport to the installation site
•
The EP1 model can be moved directly to the installation site using the existing carriage (see section
The EP2 and EP3 | FH models must be transported to the installation site with a forklift or lift truck in accord-
ance with the general safety regulations.
