22
BA_BM_ERGOPLAN-1-2-3_EN_46-21.docx
11.3
Undercarriage (Model EP1 only)
In order to move the work and assembly table to another place of use,
the undercarriage of the EP1 can be folded out. However, the load-
bearing capacity of the construction is designed exclusively for trans-
porting the Ergoplan. Therefore, the undercarriage should never be
unfolded and used with a loaded table.
Before moving the work and assembly table,
the load must always be removed!
Figure 15: Prepare undercarriage
Important Measure for Preparation:
For proper functioning of the undercarriage, the height of the Ergoplan table must first be set to approx. 161
mm (see
Figure 15 above). Then proceed as described below.
To unfold the undercarriage, the hand lever supplied is needed (see
Figure below).
Figure 16: Fold out and move the undercarriage
1.
Turn the castors inwards (parallel to the table).
2.
Position the lever to the far right and insert it
into the receptacle (
A
) up to the stop.
3.
Turn the hand lever firmly to the left until it
stops while holding the table a little.
4.
The hand lever must hold itself in position at
approx. 45° and the undercarriage folds out.
5.
Remove the lever and move the Ergoplan to the new location. Move the last 30 cm in front of the stand
transversely to the rear so that the castors at the location (see step
1.) are parallel to the front edge.
6.
Now insert the lever from the left position (see step
4.) into the receptacle (
A
).
7.
Then turn the hand lever all the way to the right until the undercarriage is unloaded again.
Caution! The hand lever can snap back dangerously and cause bruises and broken bones on
hands, legs and the entire body!
8.
Now pull off the hand lever and stow it away
→
The table now stands on its four feet again.
9.
Finally, check that the Ergoplan has a secure, wobble-free stand. If the surface is uneven, level the Ergoplan
with the adjusting screws on the four feet (see section
161 mm
A
