Qwizdom Actionpoint, Руководство пользователя

Страница: 11 / 38

Chapter 3 10
Qwizdom Actionpoint 2007
5 Chapter 3
5.1 RF Remote Setup
Follow the steps below to set up remotes. Be sure the RF host * is properly installed before
proceeding.
v.857 host or higher is required for Qwizdom Actionpoint. If the host is not v.857 host or higher, please contact
Technical Support to update your hardware.
·
Estimated Maximum Number of Remotes -the number of remotes that will
be in use for presentation. Class/group sizes vary, so it's best to enter the
highest estimated amount of remotes rather than accommodating each
class/group.
·
Enable Backlight -activates the back light on the Q5 RF participant and
instructor remotes.
·
Fixed Set -select this mode if you are K-12 or Corporate setting. Fixed Set is
where the remotes are assigned with an internal number (assigning fixed
numbers) where logging in by ID is mandatory.
·
Roaming or Participant Owned -check this option if the participants own the
remotes. This mode is best-suited for Higher Ed/University settings.
Participants are required to either enter a Session ID or Participant ID to join a
presentation.
1. Click on the Configuration Settings button. The Configuration Settings window
appears.
2. Enter an estimated number of remotes that will be used.
3. Depending on the setting, select Fixed Set or Roaming Set/Participant Owned .
4. If not, click OK .
Session IDs
When using Q4 RF and Q5 RF remotes for the first time, the remotes may ask for a session
ID. Session IDs "assign" the remote to the host. The remote identifies and communicates