1
3
2
A
1. Select position Nordic single tap
Select a suitable position for the Nordic
single tap based on the type of sink and
position of the mixer tap.
2. Drilling hole for Nordic single tap
Using the correct drill bit, drill a hole of
32 mm through the work top for the Nordic
single tap. Note: For the Nordic mixer tap
please refer to the separate guide. In the
case of a hole of 35 mm or larger, use the
centring ring provided.
3. Drilling hole for Fusion or Flex tap
Select a suitable position for the tap.
Using the correct drill bit, drill a hole of
35 mm through the work top. When doing
this, take into account the range of the
tap’s spout from the centre of the tap hole.
Drilling hole
• Note: The tap hole for the Nordic single tap should be 32 mm in diameter.
The Fusion and Flex tap hole should be 35 mm in diameter.
• The Nordic single tap should ideally be positioned at the corner of the sink to enable use
above the sink or the work top.
• Note: It must be possible to move the spout of the Nordic single tap freely up and down.
When the spout is in its lowest position it projects ca. 25 cm below the work top. Bare this in
mind when fitting the inlet combination, sockets and the like.
• Note: The Flex tap counterweight must be able to move freely. When the hose is not
withdrawn it hangs approximately 40 cm below the work surface. Make allowances for
this when fitting the inlet combination, power sockets and so forth.
Dimen
sion
s in mm
M
ax. thick
ness 60
Ø52
Hole Ø35
225
±70
Dimen
sion
s in mm
M
ax. thick
ness 50
Ø50
Hole Ø32
±70
160
Dimen
sion
s in mm
M
ax. thick
ness 50
Ø50
Hole Ø35
225
±70
Q
M
Q
M
Nordic single tap
Mixer tap
