1
3
2
4
1. Connect the hoses
Connect the hot water and cold water
hoses on the tap.
2. Tap through work top
Push the tap through the hole in the
work top.
3. Securing tap
Position the brass fixing plate around the
hoses. Screw the fixing nut onto the tap
thread. Adjust the position of the tap to
ensure that the Quooker logo is facing
the user. When the handle is in the cold
position, it will be parallel to the edge of
the work top. Tighten the fixing nut with a
pipe wrench, socket wrench or spanner.
4. Connecting hoses
Insert the inlet hose screens and connect
the hot and cold water inlet hoses to the
mains.
Fitting to thin work top
When fitting to a thin work top, use the
white tap support underneath the brass
fixing plate.
Fitting Fusion tap
• Note: The total length of the hose between the single tap and tank is only 70 cm. The tank
must therefore be fitted close to the tap. Extension hoses for the boiling water hose are
available in different lengths but are not normally required.
• Note: The small fibre washers supplied with the tap rings are not required yet at this point. One
will be used for connecting the tap and tank hose (see section E), the second one is a spare.
B
2
