Quinton TM55, Руководство пользователя

Страница: 22 / 46

3-8 Maintenance/Troubleshooting Cardiac Stress Treadmills User Guide
Troubleshooting Guide
Problem Possible Cause Remedy
Treadmill will not run Treadmill or monitoring
system power cord is not
plugged in.
Plug in power cords.
Interface cable disconnected
or damaged
Plug in and secure interface cable.
Replace if damaged.
Monitoring system power off. Turn on power. Check AC power, if
necessary.
Circuit breaker on treadmill
hood reads OFF.
Set the circuit breaker switch on the
treadmill to ON.
1.
Start
key not selected.
2. Not in proper menu.
Press proper key on monitoring system
control panel. Consult stress test
system user guide.
No power at outlet Check building circuit breaker.
Voltage below nominal Provide dedicated line for treadmill.
Emergency Stop button has
been unplugged.
Plug into connector on front of hood.
Emergency Stop button
activated.
Turn emergency stop button counter-
clockwise to deactivate.
Internal problem. Service required. Contact an
authorized technician.
Walking belt too far
left or right
Improper belt tracking. Adjust tracking (see “Belt Tracking” on
page 3-4). If problem persists, contact
an authorized technician.
Walking belt slips,
but front roller turns.
Improper belt tension Adjust belt tension (see “Belt Tension”
on page 3-3). If problem persists, con-
tact an authorized technician.
Walking belt
hesitates; adjusting
walking belt tension
is ineffective
Internal drive belt slipping. Service required. Contact an
authorized technician.
Treadmill will not
change grade.
Excess weight on treadmill. See Appendix B for maximum load.
Internal problem. Service required. Contact an
authorized technician.
Circuit breaker trips
during normal
operation.
Power fault. Service required. Contact an
authorized technician.
Error messages on
stress test monitor
Refer to monitoring system
user guide.
Refer to monitoring system user guide.
Internal problem Service required. Contact an
authorized technician.