C-4 Receiving and Installation
MedTrack Rehabilitation Treadmills User Guide
Placing Hood on Treadmill
5. Slide the hood forward while holding it in the tilted
position. (Spread the hood apart slightly to clear the
upright.)
6. Lower the hood, aligning the slots in the bottom of the
hood with the screws in the side rails (previous figure).
7. With the screws engaged in the slots, slide the hood
forward approximately 1/2-inch and tighten it in place.
8. Align the two holes inside the front of the hood with the
holes in the side rail. Install a star washer onto the two 1/
4-20 x 1-in Phillips-head screws supplied with the
treadmill, then use the screw to fasten the hood to the
frame.
Due to regulatory requirements in some countries, your
treadmill may have a grounding bracket attached to each
upright. Use the two #10 self tapping screws provided to
connect the brackets to the treadmill hood (see next
page).
Upright bracket
Upright bracket
Front end
cap
Front end
cap
Engage keyhole slots
with hold-down
screws here.
Engage keyhole slots
with hold-down
screws here.
Tilt, then
slide forward.
Tilt, then
slide forward.
Keyhole slots
on this end
Keyhole slots
on this end
Side rail
Side rail
