Quietside QVM9 Series, Руководство пользователя

Страница: 5 / 44

3
QVM 9
Series
FOR YOUR SAFETY READ BEFORE OPERATING
OPERATING INSTRUCTION
TO TURN OFF GAS TO APPLIANCE
Safety Issues
A. THIS APPLIANCE DOES NOT HAVE A PILOT. IT
IS EQUIPPED WITH AN IGNITION DEVICE
WHICH AUTOMATICALLY LIGHTS THE BURNER.
DO NOT TRY TO LIGHT THE BURNER BY
HAND. LIGHTING BY HAND COULD CAUSE
PERSONAL INJURY OR DEATH.
B. BEFORE LIGHTING : SMELL ALL AROUND
THE APPLIANCE AREA FOR GAS. BE SURE
TO SMELL NEXT TO THE FLOOR BECAUSE
SOME GAS IS HEAVIER THAN AIR.
WHAT TO DO IF YOU SMELL GAS
y DO NOT TRY TO LIGHT ANY APPLIANCE.
y DO NOT TOUCH ANY ELECTRIC SWITCH;
DO NOT USE ANY PHONE IN YOUR HOME.
y IMMEDIATELY CALL YOUR GAS SUPPLIER
FROM A NEIGHBOR
’
S PHONE. FOLLOW THE GAS
SUPPLIER ’ S INSTRUCTIONS.
y
IF YOU CANNOT REACH YOUR GAS SUPPLIER,
CALL THE FIRE DEPARTMENT OR 911.
1. STOP! READ THE SAFETY INFORMATION
ABOVE ON THIS LABEL.
2. SET THE SYSTEM CONTROLLER TO THE
LOWEST SETTING.
3. TURN OFF ALL ELECTRIC POWER TO
APPLIANCE.
4. THIS APPLIANCE IS EQUIPPED WITH AN
IGNITION DEVICE WHICH AUTOMATICALLY
LIGHTS THE BURNER. DO NOT TRY TO LIGHT
THE BURNER BY HAND.
5. TURN KNOB OF GAS VALVE TO
“
OFF
”
POSITION.
6. WAIT A FEW MINUTES TO CLEAR OUT ANY
GAS. THEN SMELL FOR GAS, INCLUDING
NEAR THE FLOOR. IF YOU DON
’
T SMELL GAS,
GO TO THE NEXT STEP.
7. TURN KNOB OF GAS VALVE TO “ ON ” POSITION.
8. TURN POWER SWITCH TO “ ON ” POSITION.
9. SET THE SYSTEM CONTROLLER TO DESIRED
SETTING.
10. IF THE APPLIANCE WILL NOT OPERATE, FOLLOW
THE INSTRUCTIONS
“
TO TURN OFF GAS TO
THE APPLIANCE
”
AND CALL YOUR SERVICE
TECHNICIAN OR GAS SUPPLIER.
1. SET THE SYSTEM CONTROLLER TO THE LOWEST SETTING.
2. PRESS THE POWER SWITCH ON ROOM THERMOSTAT (IF SO EQUIPPED) TO
“ OFF ” POSITION (LIGHT
TURNS OFF).
3. TURN KNOB ON GAS VALVE (CONNECTED TO THIS APPLIANCE) TO “ OFF ” POSITION.
C. DO NOT USE TOOLS TO PUSH IN OR TURN
THE GAS SHUT OFF VALVE. IF THE GAS
CONTROL VALVE WILL NOT PUSH IN OR TURN
BY HAND. DO NOT TRY TO REPAIR IT, CALL A
QUALIFIED SERVICE TECHNICIAN. FORCE OR
ATTEMPTED REPAIR MAY RESULT IN A FIRE
OR EXPLOSION.
D. DO NOT USE THIS APPLIANCE IF ANY PART
HAS BEEN UNDER WATER. IMMEDIATELY
CALL A QUALIFIED SERVICE TECHNICIAN TO
INSPECT THE APPLIANCE AND TO REPLACE
ANY PART OF THE CONTROL SYSTEM AND
ANY GAS CONTROL WHICH HAS BEEN UNDER
WATER.
E. DO NOT OPERATE APPLIANCE UNLESS UNIT
IS FILLED WITH WATER AND WATER LINES
ARE FULLY OPEN.