QuickJack BL-3500, Инструкция по установке и эксплуатации

Страница: 15 / 32

15
STEP 10
Jack Preparation
1. Place both QuickJack frames on a stable floor
surface with both lock bars positioned outwards as
illustrated below.
2. Check for proper tension on the safety lock bar
retaining nuts. The safety lock bars should remain upright
in the stowed position during normal use. They should be
manually engaged when required.
3. Remove any dirt, scales, chips or any foreign debris
from your quick-connect fittings to avoid contamination or
malfunction of the equipment.
4. TO CONNECT: Install the male fitting into the female
fitting. Full connection is made when the ball release
sleeve slides forward on the female fitting.
TO DISCONNECT: Hold the male fitting then retract the
sleeve on the female fitting until the fittings disconnect.
5. For AC Power Units connect directly to a 110-volt
power source.
6. For DC Power Units connect the 12-volt negative
source to the negative terminal and the 12-volt positive
power source to the positive terminal. See below images
or follow instructions accompanying the unit.
VISUALLY CHECK QUICK-CONNECT FITTINGS FOR
CORRODING, CRACKING, DAMAGE OR
EXCESSIVE WEAR. IF ANY OF THESE
CONDITIONS EXIST, THE QUICK-CONNECT
FITTINGS MUST BE REPLACED.