INSTRUCTIONS FOR
TROLLEY JACK 2TONNE HIGH LIFT LOW ENTRY
MODEL NO:
2200HL.V3
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
1. SAFETY
9
Ensure the jack is in sound condition and good working order. Take action for immediate repair or
replacement of damaged parts.
9
Use genuine parts only. The use of unauthorised parts may be dangerous and will invalidate the
warranty.
9
Locate the jack in a suitable, well lit, work area.
9
Keep work area clean and tidy and free from unrelated materials.
9
Use jack on a level and solid ground, preferably concrete. Avoid tarmacadam as jack may sink in.
9
Place suitable wheel chocks under wheels of the vehicle.
9
Ensure the vehicle handbrake is engaged, engine is switched off and transmission is in gear
(or “Park” if automatic).
9
Ensure minimum distance of 0.5m between vehicle and static objects such as doors, walls, etc.,
to allow for vehicle tilting.
9
Ensure there are no passengers in the vehicle.
9
Ensure all non-essential persons keep a safe distance whilst the jack is in use.
9
Only place jack saddle under those lifting points recommended by the vehicle manufacturer
(see vehicle handbook).
9
Check the lifting point is stable and centred on the jack saddle.
9
Ensure the jack wheels are free to move and that there are no obstructions.
9
Use suitable capacity axle stands under the vehicle before proceeding with any task.
9
Ensure there are no persons or obstructions beneath the vehicle before lowering.
9
Use a qualified person to maintain or repair the jack hydraulic system.
9
When not in use store jack, fully lowered, in a safe, dry, childproof area.
8
DANGER
: Use the jack for lifting only.
8
DO NOT
use for supporting the lifted load.
8
DO NOT
operate the jack if damaged.
8
DO NOT
allow untrained persons to operate the jack.
8
DO NOT
exceed the rated capacity of the jack.
8
DO NOT
allow the vehicle to move while supported by the jack, or use the jack to move the
vehicle.
8
DO NOT
jack the vehicle if there is a risk of spillage of fuel, battery acid, or other dangerous
substances.
8
DO NOT
work under the vehicle until axle stands have been correctly positioned.
8
DO NOT
use the jack for purposes other than that for which it is intended.
8
DO NOT
top up the hydraulic system with brake fluid. Use hydraulic jack oil only.
8
DO NOT
adjust the safety overload valve.
2. INTRODUCTION
High lift jack arm with incredibly low access height of just 80mm. Fitted with quick lift foot pedal and dead man’s control. Heavy-duty long steel
chassis with wide wheelbase provides inherent stability and easy access to deep set jacking points. Fitted with one-piece hydraulic unit with
built-in safety overload protection.
3. SPECIFICATION
Model no: ............................................................. 2200HL.V3
Capacity: ..................................................................... 2tonne
Minimum saddle height: ............................................... 80mm
Maximum saddle height: ............................................ 805mm
Maximum chassis height: ........................................... 220mm
Length: ....................................................................... 950mm
Weight:........................................................................... 51kg
2200HL.V3 | Issue:1 31/08/17
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear
safety
footwear
Apply
Chock
Wheels
Never
exceed
X2
