17
• When you observe oil exiting the cylinder without
bubbles, the air has been removed.
• Tighten the hex socket bleed screw using a
hexagon wrench to close and create a tight seal. DO
NOT OVERTIGHTEN.
2.
REMOVING PACKING OIL FROM AIR CHARGE
CYLINDERS.
• Using a pump or air compressor, inflate each air
bottle cylinder to 50-PSI.
• Use a valve tool or blunt-nose tool to depress the
valve core plunger to release any accumulated
packing oil from the air charge cylinders. WARNING:
Lay a towel or cloth over the inflation valve during
this process to prevent oil mist from contaminating
the immediate area and/or or to prevent oil mist from
entering eyes. See image below.
• Repeat steps until air charge cylinders are
completely drained of packing oil.
• Place contaminated materials in disposable
containers and dispose of in a manner consistent
with applicable regulations.
STEP 12
Operation and Use
There are two methods of using the QuickJack when
raising vehicles;
INSIDE OUT
and
OUTSIDE IN.
•
INSIDE OUT:
In this method, the QuickJack frames
are positioned directly adjacent each other while the
vehicle rolls over into position. Quick Frame Handles are
typically required. See below.
Quick Frame Handles are easily installed by simply lifting
the jack frames and placing the end channel underneath
the frame tubes as shown below.
•
OUTSIDE IN
: In this method, the QuickJack frames
are positioned wide enough for vehicle entry. Quick
Frame Handles are typically not required. DO NOT
drive over hydraulic hose. See below.
IMPORTANT NOTE:
Before loading, both jack frames must be fully
lowered and working area cleared of any obstruction
before vehicle is brought into position.
DO NOT
drive on
or ride vehicles over jack frames at any time.
1. Position four Rubber Lift Blocks in the receiver trays as
shown below.
GET FAMILIAR WITH OPERATOR CONTROLS BY
RUNNING THE JACKS THROUGH A FEW CYCLES
BEFORE LOADING VEHICLE ON QUICKJACK.
DURING PRESTART TESTING WITH NO LOAD,
THE JACK FRAMES MAY NOT RAISE AND
LOWER EVENLY. THIS IS NORMAL. DURING
PRESTART TESTING WITH NO LOAD, DO NOT
RAISE FRAMES TO FULL HEIGHT, RAISE
MIDWAY ONLY.
Содержание BL-3500
Страница 4: ...4...
