Quickie Pulse 6 BC, Руководство пользователя

Страница: 21 / 106

119832 Rev. B 21
E N G L I S H
Back Height Adjustment
1. There are 3 positions of Adjustment for the back with 1” increments.
Position 2 (+2) (A), Position 1 (+1) (B), and Position 0 (default) (C)
a. Using a 5mm Hex Key, remove the M8 flat head screws (3) on each side
b. Position the backrest at the desired height. Top screw should be mounted as shown
(Figure 26).
c. Holding the backrest in place, tighten the screws.
d. Repeat steps with other side, and ensure that the left and right sides are positioned at
the same height.
Armrest Width Adjustment
NOTE–
You can change the armrest widths independantly, remember that this adjustment will
increase the overall width of the Wheelchair.
1. Changing the armrest Width
a. Locate the 2 armrest fasteners (D) on each side of the armrest receiver bracket (fig-
ure 27)
b. Loosen the fasteners
c. Slide the armrests in or out to the desired width.
d. Re-tighten the fasteners.
Armrest Height Adjustment
1. To change the armrest Height.
a. Using a 4mm Hex Key, Loosen the two M5 setscrews (E) located on the armrest
receiver (figure 28)
b. Raise or lower the armrest to the desired height
c. tighten the setscrews to secure the armrest
Armrest Angle Adjustment
1. To change the armrest angle (Figure 29)
a. Lift the armrest straight up so that it is perpendicular to the floor
b. Loosen the jam nut (G)
c. Turn the adjusting screw (F) to raise or lower the front of the armrest
d. Tighten the Jam nut (G) to lock the adjusting screw into place.
e. Make sure that armrest knob (H) is tight when finished.
26
27
28
29
VIII.
A
B
C
D
E
F
G
E
H