ENGLISH (111:02)
111
*The floating function is coupled when the control
device is brought maximally forwards. The lever should
then stay in this position. Decoupling is made by
bringing the lever in the reverse direction.
** Concerns right-hand mounted control device. As
regards left-hand mounted control device it is possible
to obtain reversed lever movements by shifting the
hydraulic hoses marked yellow-red. See the instruction
supplied with the hydraulic set.
Safety Block: The control device is equipped with a
catch, see illus. 16, which, in locking position (left),
prevents involuntary operating.
Electrical switch (applies to loaders equipped with
electric switch valves)
The lever knob, supplied with the electric valves, is
equipped with three switches acc. to illus. 35.
Function:
Sliding switch (B) in position (1)
and lever in control position for implement function.
Push button (A) = Valve (3rd) in function
Push button (C) = Valve (4th) in function
Sliding switch (B) in position (2)
Push button (A) = Valve (5th) in function
Push button (C) = Valve (4th) in function
Note:
If only one valve (3rd) is mounted, the switch (B) can
be brought into position (2) to prevent involuntary
connection of the valve. This is recommended if the
loader is equipped with hydraulic implement change.
16
- For maximum stability and to avoid skidding, always
carry implement with load as low as possible.
- When driving the implement into the material to be
handled, always make sure that the valve is in a
neutral position, otherwise the front of the tractor
tends to rear at the moment of drive-in, which would
entail strains on both loader and tractor.
Keep to the following rules: NEVER drive at full speed
into the material. Select a low gear for the best traction.
COUNTER WEIGHT: For overloading and safety
reasons, always use counter-balance with weights
when carrying heavy materials or implements with large
out-reach.
See safety instructions, page 105.
Do not leave the tractor with the loader in ”lift” position
and do not stand beneath the load.
When changing implements, always check that the
implement is properly locked in position by pressing the
front end of the implement to the ground.
OPERATING (Applies to loaders with separate control
valve.)
The control device (MONO handle) has the following
functions:
Lever Movement:
Backwards -
Loader beam is lifted
Forwards
-
Lowering of loader beam + floating
position*
Left ** -
The implement is crowded upwards
Right **
-
The implement is dumped
DRIVING INSTRUCTIONS AND MAINTENANCE
35
