Quick MC2 Series, Инструкция по установке и эксплуатации

Страница: 31 / 40

31
EN
INSTALLATION AND USE MANUAL QUICK MC² X3_DC REV001A
DC
DC
9 - Start-up
Before you start, follow the indicated sequence to properly execute the mechanical and electrical
installation operations described in the previous sections.
Before the start-up, the protections that had been previously removed must be put back in place, and the
area surrounding the stabilizer must be cleared of personnel and equipment.
9.0 - Introduction
This section describes the first start-up of the stabilizer.
9.1 - Start-up instructions
Switch on the stabilizer via the MC
2
RC Remote Control panel (refer to the MC
2
RC Remote Control Panel user's manual).
10.1 - Warnings
• Before any maintenance operation disconnect the power supply and make sure that the
FLYWHEEL HAS COMPLETELY STOPPED.
• The warranty does not cover, under any circumstances, damages to property/ people, in the
event that maintenance (of any type) is carried out before the stabilizer is disconnected from
the power supply and the mass is completely still.
• Restore the power supply only after having correctly refitted all the safety devices that were
previously removed.
10.0 - Introduction
Quick MC
2
gyro stabilizers are built with materials resistant to the marine environment.
Maintenance is however mandatory, even if no problems occur.
Quick
®
recommends a periodical inspection every 2000 hours and an annual one.
10 - Maintenance
* Warning: in order to activate Quick warranty, an installation validation and
the first start-up (commissioning) must be carried out by Quick
authorized personnel only.