Quick Salt QUICKSALT20, Руководство пользователя

Страница: 10 / 28

MANUAL DE USUARIO
10
Please first identify the following elements in your pool installation:
If your installation does not have valves to close the water flow, you must drain the pool before
installing the equipment, otherwise all the water in the pool could be drained through the cut of
the pipe.
1) Turn the filter selector valve to the “close”
position.
2) Close the supply valves and, if available, the
return valves as well.
3) Disconnect the power supply in the area
where the equipment is to be installed, through
the general electrical panel.
4) Keep in mind that you will have to cut a
section of pipe and it is likely that this section is
full of water. Make sure you have the means to
collect this water when cutting
5) Do not, under any circumstances, use power
tools to cut the PVC pipe. Use a hand saw.
Please note that the QUICKSALT chlorinator
must always be installed after the pump and
filter. That is to say, on the drive. It is very
important that you identify the direction of the
water flow so that the elements are placed in
the following order:
2.3. Hydraulic installation
Attention: Make sure you have a long enough length of pipe to install the
electrolysis cell and flow sensor.
Pump control panel (1)
Filtration pump (2)
Filter (3)
Water flow sensor – Flow switch (4)
Temperature sensor (5) – Optional Kit
QUICKSALT chlorinator (6)
Security warning
It is always preferable that the pool is empty before installing the equipment.
However, if your pool is full and you do not wish to empty it, you should
carefully follow the instructions below:
Direction of the water flow
Drive
1
3
4 5
6
2