Quick MILL Uragano Compact 0998, Инструкция по эксплуатации

Страница: 14 / 27

Mod. 0998 2GR. Uragano Compact Rev. 00
The machine comprises a boiler for dispensing water and
steam; there are some transverse heat exchangers inside
it to heat the water for coffee dispensing.
The machine comprises a stainless steel load-bearing
structure; the two sides of the body are made of
polyurethane foam and all the panels are made of AISI
304 stainless steel.
3.2 Safety
The boiler has a mechanical overpressure spring valve
calibrated to 2.3 bar, as well as a thermal protector that
switches off the heating process in case of failure.
The hydraulic circuit for coffee dispensing has a safety
valve calibrated to 12 bar.
The pump has a thermal protector with automatic reset
that protects it in case of overheating.
All heating components and those subjected to electric
voltage are located inside the machine’s panels.
4. LEGEND
FIGURE 1
12 Main switch (0/1/2)
13 Dual scale pressure gauge
14 Coffee unit
15 Filter holder
16 Steam valve
17 Hot water valve
18 Dispensing commands push-button panel
19 Cup warmer surface
FIGURE 3
20 Machine On indicator light
21 Boiler minimum level indicator light
22 Heating indicator light
5. INTENDED USE
This machine was designed and built to dispense coffee
and prepare hot drinks (tea, cappuccino, etc.)
Any other use should be considered inappropriate and
thus dangerous.
The operator should always follow the operating and
maintenance instructions found in this instruction
manual.
In case of doubt or operating defect, stop the
machine; do not carry out any repairs or direct
interventions but contact an authorised service
centre.
The operator should never:

touch the hot surfaces with his/her hands but only
use the proper controls;

carry out maintenance operations or transport the
machine when plugged in and hot;

unplug the machine by pulling on the power cord;

use the machine if the power cord is damaged;

touch the machine with wet or damp hands or feet;

turn the package and the machine upside down or
lay it on its side.

wash the machine with direct or high-pressure water
jets or with steam;

immerse the machine in water or other liquids;

use the machine when there are minors in the
immediate vicinity;

let incapacitated persons or minors use the machine;

set containers holding liquids on the machine.
If the machine is wet or very damp, do not proceed with
installation and operation until you are sure that it has
been dried completely.
In any case it is necessary to have a precautionary check
carried out by the service centre to determine if the
electrical components have been damaged.
Contraindications for use
The machine should only be used as intended and not for
other purposes, for example to grind and dispense
products other than coffee.
6. TRANSPORT
6.1 Transport
During transport, always keep the package in the correct
position as indicated on the outside of the carton.
Do not turn the package upside down or lay it on its side.
6.2. Packing
The package contains the detached parts and the
accompanying documentation, which should be kept for
future consultation.

Open the upper part of the package, remove the
accessories and then remove the machine from the
wrapping.

Make sure that the machine and the accessories are
complete and undamaged (
Figure 2 ) according to
the table below.
2 UNITS
Hose for connection to water supply
system (Fig. 2 pos. 12)
1
3/8” gaskets (
Fig. 2 pos. 13)
2
Brush (Fig. 2 pos. 14)
1
Blind filter (Fig. 2 pos. 15)
1
1 cup filter holder (Fig. 2 pos. 16)
1
2 cup filter holder (Fig. 2 pos. 17)
1

Make sure that the power cord is in good condition;
if damaged, promptly notify the retailer.
Do not leave packaging items (plastic bags,
expanded polystyrene, nails, cardboard boxes,
etc.) within the reach of children as they are
potentially hazardous.
Do not disperse the packaging items in the environment
but dispose of them properly.