Smart Module Series
SC200R&SC262R_Series_Hardware_Design
13 / 124
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify
compliance as a composite system. When testing the host device for compliance with Part
15 Subpart B, the host manufacturer is required to show compliance with Part 15 Subpart B while the
transmitter module(s) are installed and operating. The modules should be transmitting and the evaluation
should confirm that the module's intentional emissions are compliant (i.e. fundamental and out of band
emissions). The host manufacturer must verify that there are no additional unintentional emissions other than
what is permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.
Important Note notice that any deviation(s) from the defined parameters of the antenna trace, as
described by the instructions, require that the host product manufacturer must notify to Quectel Wireless
Solutions Co., Ltd that they wish to change the antenna trace design. In this case, a Class II permissive
change application is required to be filed by the USI, or the host manufacturer can take responsibility through
the change in FCC ID (new application) procedure followed by a Class II permissive change application.
End Product Labeling
When the module is installed in the host device, the FCC/IC ID label must be visible through a window
on the final device or it must be visible when an access panel, door or cover is easily re-moved. If not, a
second label must be placed on the outside of the final device that conta
ins the following text: “Contains FCC
ID: XMR2022SC262RWF
”
The FCC ID can be used only when all FCC compliance requirements are met.
Antenna Installation
(1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
(2) The transmitter module may not be co-located with any other transmitter or antenna.
(3) Only antennas of the same type and with equal or less gains as shown below may be used with this
module. Other types of antennas and/or higher gain antennas may require additional authorization for
operation.
(4)
The max allowed antenna gain
for 2.4G Hz
is
0.47
dBi
with
external antenna.
The max allowed
antenna gain for 5GHz is 1.28 dBi with external antenna.
In the event that these conditions cannot be met (for example certain laptop configurations or co-location
with another transmitter), then the FCC authorization is no longer considered valid and the FCC ID/IC
ID cannot be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC/IC
authorization.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove thi
s RF module in the user’s manual of the end product which integrates this module. The end
user manual shall include all required regulatory information/warning as show in this manual.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)
This device may not cause harmful interference, and (2) this device must accept
any interference
received, including interference that may cause undesired operation.
This
device complies with ISED’s licence-exempt RSSs. Operation is subject to the following two
conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any
interference
received, including interference that may cause undesired operation.
