LTE Standard Module Series
EC25 Hardware Design
EC25_Hardware_Design 66 / 130
3.18. STATUS
The STATUS pin is an open drain output for indicating the module’s operation status. It can be connected
to a GPIO of DTE with a pull-up resistor, or as LED indication circuit as below. When the module is turned
on normally, the STATUS will present the low state. Otherwise, the STATUS will present high-impedance
state.
Table 22: Pin Definition of STATUS
The following figure shows different circuit designs of STATUS, and customers can choose either one
according to customers’ application demands.
Figure 30: Reference Circuits of STATUS
The status pin cannot be used as indication of module shutdown status when VBAT power supply is
removed.
3.19. Behaviors of RI
AT+QCFG="risignaltype","physical"
command can be used to configure RI behavior.
No matter on which port a URC is presented, the URC will trigger the behaviors of RI pin.
Pin Name Pin No.
I/O
Description
Comment
STATUS 61
OD Indicate
the module’s operation status
An external pull-up resistor
is required.
If unused, keep it open.
NOTES
