PiXtend
Construction manual:
PiXtend V1.3 Full
Kit Assembly
If all resistors are placed and fixed by a soldering joint, then the circuit board can get
turned and the second connection wire get soldered.
On the bottom side it should be checked, if on the already fixed connection wires the
solder flew down through the hole. If not the soldering point can be heated again and feed
with more solder if necessary.
The connection wires of the resistors get cut again with the cutter.
www.pixtend.de
Copyright by Qube Solutions UG (limited liability)
36 / 75
Figure 30: Placing resistors
Figure 31: Good soldering joints
(Solder cone on the pad )
