Quantum ValueLoader DLT VS160, Руководство пользователя

Страница: 59 / 88

Diagnostics and Troubleshooting
Troubleshooting
ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual 45
To terminate the ValueLoader, locate the terminator in the
accessories package and press it firmly into the either of the two SCSI
connectors on the back panel of the ValueLoader. Secure the
terminator by tightening the finger-screws until snug. The supplied
terminator is “dual mode” and will work on both LVD and SE SCSI
buses. A green LED on the terminator indicates that the unit is
attached to a SCSI bus running in LVD mode. A red LED on the
terminator indicates that the unit is attached to a SCSI bus running in
SE mode. If the LED is not on, check all SCSI and power connections
and confirm that the unit is attached to a valid SCSI bus.
•
Compatibility:
Ensure that the ValueLoader is compatible with the
SCSI host adapter and backup application you plan to use. For a list
of compatible SCSI adapters and application software, check with
your SCSI host adapter manufacturer, backup application vendor, or
support at
www.Quantum.com
.
•
SCSI Host Adapter Installation:
Verify that you have installed your
SCSI host adapter correctly. Refer to the manual that came with your
SCSI host adapter for installation and troubleshooting instructions.
Pay particular attention to any steps describing the settings of various
jumpers and/or switches on the host adapter, or on newer adapters,
the setup application for the adapter. Make sure that the host adapter
is properly seated in the motherboard slot and the operating system
correctly detects the host adapter. Make sure that the proper device
driver is installed for the SCSI host adapter.
•
Backup Application Installation:
Refer to the documentation included
with your backup application for instructions on how to verify
proper installation. Most backup software packages require an
additional module to communicate with the ValueLoader robotics.
•
Device Driver Installation:
Make sure that the proper device driver, if
applicable, is installed for the ValueLoader (see Installing the Device
Drivers on page 15). Also refer to
www.Quantum.com
for more
information.