Installing a Second Tape Drive or Replacing a Tape Drive
3
LTO-5 Full-Height Tape Drive
5
Connect the other end of the AC power cable to the rack/facility AC power
receptacle.
6
Press the master AC power switch on the front of the 3U Rackmount enclosure to
apply power to the enclosure and illuminate the power LED (see
Figure 3
).
Figure 3 Power Button
Power switch
Power LED
7
Turn on all attached accessory devices, such as printers and other SCSI devices that
you turned off at step 2 of this procedure.
8
Turn on and restart the host server.
Installing a Second Tape Drive or Replacing a Tape Drive
Follow these instructions to install a second tape drive or to replace a tape drive after it
has been removed.
Caution:
Before installing a second tape drive, you must turn off the 3U Rackmount
enclosure and disconnect it from its AC power source.
Preinstallation
Requirements
Before installing a second tape drive in the 3U Rackmount enclosure, make sure you
have the following required tools and parts:
Tools
#2 Phillips screw driver
Parts
• A supported model tape drive
• SAS cable depending on the tape drive type