Quantum 1402
www.quantumrehab.com
35
V I I . O P E R A T I O N
!
Ripple up and down of lights: The joystick was not in the centre position when the controller was turned on. If you
get “ripple up and down of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
NOTE: If you still get “ripple up and down of lights,” contact your Quantum Rehab Specialist. When the
batteries approach a discharged state, the first red light will begin to slowly flash, reminding you the batteries
need to be charged immediately!
Speed Settings
The Remote Plus speed settings range from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting is
5. The settings are indicated by the number of lights that are lit.
NOTE: The speed settings are preset at the factory. If your Quantum Rehab Specialist changes the order of these
settings, please make note of these changes. Contact your Quantum Rehab Specialist for more information.
To select a speed setting:
1. Press the on/off key to power on the remote.
2. Press the mode key once.
3. To increase chair speed, push the joystick to the right. Each time you push the joystick, you will increase the
speed setting.
4. To decrease chair speed, push the joystick to the left. Each time you push the joystick, you decrease the speed setting.
5. Once you select the desired speed setting, press the mode key once to keep the setting or push the joystick in the
forward or reverse direction. The chair will resume operation at the selected speed.
NOTE: We recommend that the first few times you operate your power chair, you have your speed on the
slowest setting until you become familiar with your new power chair.
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these acces-
sories.
Off-board Charger/Programming Socket
The off-board charger/programming socket is located on the front of the Remote Plus. The off-board charger current
should not exceed 8 amps. Contact your Quantum Rehab Specialist for more information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket.
NOTE: The off-board charger/programming socket may also be used for reprogramming the Remote Plus.
Contact your Quantum Rehab Specialist for more information.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module at the back of
the power base.
