24
www.quantumrehab.com
Quantum 1402
V . C O M F O R T A D J U S T M E N T S
Seat Position
You can move the seat forward or rearward by changing the
extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the electronics tray.
3. Remove the seat from the power base.
4. Remove both extrusions from the bottom of the seat.
5. Reposition the extrusions on a different set of mounting holes.
You must move both extrusions the same number of holes
either forward or backward. See figure 16.
6. Fasten the extrusions back onto the bottom of the seat.
7. Reinstall the seat.
8. Reconnect the controller to the electronics tray.
Manual Recline Adjustment
If your power chair is equipped with an optional reclining seat,
you can adjust the seatback angle with the seatback release
lever located on the side of the seat base.
To adjust the seatback angle:
1. Pull up on the seatback release lever.
2. Move the seatback down or up to the desired position.
3. Release the seatback release lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seatback,
you can adjust it to four (4) different angles: 90°, 102°, 105° or
107°.
To adjust the seatback angle:
1. Remove the adjusting screws from both seat hinges. See
figure 17.
2. Set the seatback at the desired angle.
3. Reinstall the screws to both seat hinges and tighten.
Armrest Width Adjustment
To change the armrest width:
1. Locate the two adjustment knobs on the armrest receiver
bracket. See figure 17.
2. Loosen the knobs.
3. Slide the armrests in or out to the desired width.
4. Retighten the knobs.
Figure 17. Seatback and Armrest Adjustments
SEATBACK
ANGLE
ADJUSTING
SCREW
ADJUSTMENT
KNOB
LOCKING NUTS
ARMREST
ANGLE
ADJUSTING
SCREW
Figure 16. Seat Mounting Holes
SEAT MOUNTING HOLES
