Quantum 1402
www.quantumrehab.com
17
I I I . Y O U R P O W E R C H A I R
Electronics Tray
The electronics tray is located on the rear of your power chair. The electronics tray is located underneath the rear sliding
door and consists of the ammeter, the charger power lead receptacle, the main circuit breaker, accessory connector
(optional equipment) and the controller connector(s).
Ammeter: The ammeter displays the charger’s current output in amps. For more information, see VI. “Batteries and
Charging” in this manual. See figure 6.
Charger Power Lead Receptacle: This receptacle is used whenever your battery needs recharging. See figure 6.
Main Circuit Breaker: The main circuit breaker is a safety feature built into your power chair. When the batteries and the
motors are heavily strained (e.g., from excessive loads), the main circuit breaker trips to prevent damage to the motors and
the electronics. If the circuit trips, allow your power chair to “rest” for approximately one minute. Next, push in the circuit
breaker button, turn on the controller and continue normal operation. If the main circuit breaker continues to trip repeat-
edly, contact your Quantum Rehab Specialist. See figure 6.
Accessory Connector (Optional): This is where optional power harnesses connect to the controller.
Controller Connector(s): This is where the controller connects to the motors, batteries and charger.
Power Elevating Seat Connector (Optional): This is for the optional power elevating seat switch. See figure 6.
Figure 6. Electronics Tray
AMMETER
CONTROLLER CONNECTOR
CHARGER POWER LEAD RECEPTACLE
(SHOWN COVERED)
MAIN CIRCUIT BREAKER